If you have sceen my last post you will know that my files have all being deleted.
When reinstalling the hardware with the wizard i pushed some wrong buttons and now it says that the hardware is not connected. I know what i have done wrong i just want to know how to fix it
thanks:-)
I assume you haven't installed the drivers.
Go to device manager find RadarBox and right click on it and select update driver and point towards your RadarBox CD or RadarBox folder and then try.
thanks
it seems radarbox is not present in my device manager
If RadarBox is not in your device manager you have not connected RadarBox to your machine via the USB cable.
Quote from: cosmoc on October 30, 2008, 04:54:51 AM
it seems radarbox is not present in my device manager
Have you looked at the forum FAQ section, this one in particular:
http://www.airnavsystems.com/forum/index.php?topic=786.0
Quote from: AirNav Support on October 30, 2008, 08:31:10 AM
If RadarBox is not in your device manager you have not connected RadarBox to your machine via the USB cable.
it is definatly connected!
Quote from: cosmoc on October 31, 2008, 07:25:25 AM
Quote from: AirNav Support on October 30, 2008, 08:31:10 AM
If RadarBox is not in your device manager you have not connected RadarBox to your machine via the USB cable.
it is definatly connected!
Yes OK, but have you looked at the forum FAQ section, this one in particular:
http://www.airnavsystems.com/forum/index.php?topic=786.0
yes i have now looked at it.
it says that if you have any RB Drivers installed the rb should show up in the serial bus controller. But mine dose not?
The RB is Pluged in yet i can not find any trace of the rb on my computer?
I will have a good tinker today and see if i cant find it:-)
all the best!
What lights are on or flashing on the Radarbox hardware?
the USB light is flashing once's every second :-)
Check the Hardware section of the user manual. If it's blinking ON for half a second, and then OFF for half a second, then you've either got a cable or driver problem. To quote from the user manual:
When the blue LED blinks on for half a second and off for half a second, this indicates that the hardware is being powered by the computer but there is no valid connection between them. This could indicate the USB driver is not installed correctly or because there is a problem with your USB cable. For more information on how to properly install the drivers please go to the Installation section and the Troubleshooting section.
As per the manual, check the Installation and Troubleshooting sections. Are you using the supplied USB cable?